
This mobile tyre van conversion brings together tyre fitting equipment, an electric air compressor and a 24V auxiliary power system within an upgraded working interior.
The fit-out includes grey plywood lining, non-slip flooring, a retractable air hose reel and a rear reversing camera. The exterior was left without signwriting, with the work focused on the equipment and interior setup.
A Practical Mobile Tyre Workshop
The workshop combines a tyre-changing machine and wheel balancer with an electric compressor supplying compressed air. The equipment is arranged within the load area, with access through the side and rear doors.
A retractable air hose reel provides a convenient connection for air tools and tyre inflation equipment. The reel allows the hose to be extended when needed and retracted for storage.
Electric Air Compressor
An electric compressor forms part of this build’s onboard equipment. Its installation was planned alongside the auxiliary electrical system, bringing the air supply and power requirements together within the conversion.
The photographs show the compressor positioned towards the front of the workshop, near the wheel balancer and below the retractable hose reel.
24V Auxiliary Power and DC–DC Charging
The conversion uses a 24V auxiliary power system with DC–DC charging to support the onboard equipment. An inverter supplies the fitted mains outlets, while the installation also includes electrical distribution, isolation and a consumer unit.
These components form part of the wider electrical fit-out supporting the mobile workshop. The system specification was selected around this build’s equipment requirements.


Upgraded Grey Plywood Lining
The upgraded grey plywood lining gives the workshop a consistent interior finish around the installed equipment. Matching panels help bring the different areas of the conversion together visually.
The wheel arch enclosures sit within the same working space, with sockets and controls positioned around the equipment.
Non-Slip Workshop Flooring
The black non-slip flooring is a particularly noticeable part of this fit-out. Its textured finish runs through the workshop and contrasts with the grey wall panels.
Alongside the equipment, the floor and lining give the van a more finished working interior. The photographs show the floor area around the tyre machine, wheel balancer and access points.
Rear Reversing Camera and Cab Monitor
A rear reversing camera was fitted with a dedicated monitor mounted in the cab. The system provides a rear camera view to assist the driver when manoeuvring.
The photographs show the rear-mounted camera equipment and the monitor position on the dashboard.
Equipment and Interior Working Together
This conversion combines the core tyre workshop equipment with onboard power, compressed air and reversing assistance. The upgraded lining and flooring complete the interior around those systems.
With no exterior signwriting added, the focus of the project remained on creating a practical mobile tyre workshop with a clean, coordinated interior finish.


Explore This Service
Planning a mobile tyre fitting van? Vehicle Installers can help bring together your workshop equipment, onboard power, air supply and interior fit-out.


