
This Volkswagen Crafter tyre van conversion was built around a straightforward brief: provide the equipment needed for mobile tyre work while keeping the fit-out practical and the electrical system simple.
The build combines a customer-selected 200-litre petrol air compressor, tyre machine and wheel balancer with a 12V auxiliary electrical system, a 3000W inverter, sockets and working lights. Standard plywood lining provides a functional interior, with no decorative finish or exterior graphics added.
A Practical Mobile Tyre Workshop
This project focused on the equipment needed to do the job. The tyre machine and wheel balancer were budget-conscious choices, providing the core workshop equipment without moving into a premium specification.
A retractable air hose reel gives access to compressed air from the working area. The layout brings the compressor, tyre equipment and electrical controls together inside the Crafter to support mobile tyre fitting work.
Why a Petrol Air Compressor?
The customer chose a 200-litre petrol air compressor. By supplying compressed air independently of the van’s auxiliary electrical system, this reduced the electrical demand the conversion needed to support.
That choice helped keep the onboard power installation simpler than a setup designed to run an electrically powered compressor alongside the other workshop equipment.
There are trade-offs. A petrol compressor brings engine noise, vibration and servicing requirements. For this build, the customer preferred that approach to the additional electrical equipment that an alternative compressor arrangement could require.
12V Power and a 3000W Inverter
The auxiliary installation uses a 12V system with a 3000W inverter supplying the fitted mains sockets. With the petrol compressor handling the air supply, the electrical installation could be planned around the remaining equipment and lighting.
This earlier Crafter was fitted with a conventional split-charge arrangement. It reflects the approach used on this particular vehicle; our current builds use DC–DC charging systems, selected to suit the vehicle and installation.
A separate fuse board and switch panel provide circuit distribution and control of the added electrical features.


Lighting for the Working Area
The conversion includes interior LED lighting, together with flood lights fitted to the side and rear of the van. These provide illumination inside the workshop and around its access points.
A roof-mounted warning beacon completes the exterior lighting equipment. The emphasis throughout was on useful working features suited to the customer’s requirements.
A Straightforward Interior
Standard plywood lining and fitted sockets give the van a practical working interior. This build did not include exterior graphics or a decorative workshop finish.
The result is a straightforward mobile tyre van combining tyre fitting and balancing equipment, compressed air, onboard power and lighting. It shows how a conversion can be shaped around the customer’s equipment choices and priorities without every project needing the same specification.


Explore This Service
Planning a mobile tyre fitting vehicle? Explore our tyre van conversions to discuss a layout and equipment setup suited to your work.


